Friday, May 16, 2014

underwood FIVE




The right-hand carriage release lever has an interesting paddle shape. Next to it, notice the vestigial remnant of a little hook/handle found on all Underwood frames, back to the model no. 1.


The ribbon covers slide away to reveal the ribbons:


This ribbon mechanism is essentially the one used on noiseless portables and later Remingtons:


The front panel easily pops off. Note that the bell is now on the right; for decades it was located on the left.

Here you can glimpse two plastic gears. The one deep inside the typewriter is part of the tabulator brake, and is a little cracked. The closer one connects to a ball chain, an unusual thing to find in a typewriter.




Underwood family reunion (older models)

17 comments:

  1. Nice, clean looking machine. I don't think I have ever seen this model before. Before WWII, almost every office had an Underwood 5, but after the war, you saw more Royals and Remingtons. Your review of Underwoods through the years, raises one nagging question. Over on the left, above the top left key, there was a small, nickle plated shaft, with a slighly rounded face, but no i.d. which protruded from the vertical panel behind the keys. Was this a margin release? I grew up on an old (1930?) No.5 and remember this button, but not what it did. I know it moved less than 1/4" and took very little effort.

    ReplyDelete
    Replies
    1. It has something to do with the margin, but I forget which one, and I think it often doesn't work right. I think it's a margin release that's supposed to give you an extra few spaces after the right margin.

      Delete
  2. Cool donation, how very generous of Gerald.

    ReplyDelete
  3. Very nice donation. I am a bit suprised at the plastic gears for such a hefty looking machine. If plastic did not dry and crack it would be fine, but I find so many nice things (not typewriters generally) that are unuseable only because of a cracked plastic gear. Powdered metal is nearly as bad too.

    ReplyDelete
  4. Just wanted to add this cost me $5.00 (well $4.95)... I just like the ideal of a Underwood 5 for 5.
    Gee

    ReplyDelete
    Replies
    1. You are a master of finding typewriters for less than the cost of a ribbon! Thanks again.

      Delete
  5. That's a generous gift and I hope it goes down well at WordPlay. Just guessing, the shipping was more than the machine's price, right?

    ReplyDelete
    Replies
    1. Rob:
      I just look at shipping as my way of keeping the U.S. Post office solvent... my father worked for the U.S. Postal Service 42 years and shipping a typewriter is just giving back.

      Delete
  6. I've seen that ball chain in underwoods before. Sadly the plastic mount is likely to be increasingly fragile. I'd keep it away from direct sun as much as you could.

    ReplyDelete
    Replies
    1. The chain on the platic gear is on a shaft that is driven by something even stranger: The escapement wheel! This is the only make of typewriter I have ever seen designed like that--first used on the Golden Touch machines in 1958, Underwood used it successfully until Olivetti built the last Underwood sometime in the 1960s.

      Delete
  7. How about that. I'm going to be featuring my Touchmaster Five in tomorrow's typecast! Haha. One thing I can't figure out is the grey lever on the left side of the keyboard. Is that how you take off the front panel?

    ReplyDelete
    Replies
    1. It's the key tension adjuster.

      To remove the front panel, pull up from the front and then wiggle a bit; it will come out pretty easily.

      Delete
  8. Hi! I just found one of these next to a dumpster, in pretty good condition. I'm trying to date it, but can't find the serial number. Do you know where it's located?

    ReplyDelete
    Replies
    1. Hi, take a look at the seventh photo of the typewriter in this blog post and you'll see the serial number near the bottom of the photo. I hope it's in the same location on your machine.

      Delete
    2. Thanks! Got it, it's a 1962!

      Delete