WCPO story on WordPlay Cincy and Urban Legend Typewriters

Kristen Skovira of local TV station WCPO visited my basement last week for a story on WordPlay Cincy, the kids' creative writing center that my typewriter repair work helps to support.

You can see the story here:

Jewett no. 2 typewriter

This 1895 Jewett no. 2 is a recent addition to my collection. I haven't bought a 19th-century typewriter for years—much less a big one—but this was so pretty that I couldn't resist. It's in near-mint condition, with the original pinstripes and hand-painted details. There's even an original purple ribbon.

This serial number looks like 8113:

But note the 6113 painted inside the front frame:

That interesting notched wheel is part of the ribbon mechanism. As the carriage moves, the shaft of the ribbon spools moves horizontally, and the wheel turns one notch, ensuring that the entire 1.25-inch-wide ribbon is used in a zigzag pattern.

Take a look:

The name of the company still reflects its initial, disastrous attempt to market a typewriter that could print two characters at once. The Duplex is one of the rarest collectible machines.

 

One weird trick for making a cotter pin

The left Magic Margin stop on a customer's Royal Quiet De Luxe wasn't working. When I peeked at it, the problem was evident.

I removed the carriage's back panel and took a closer look.

Evidently, the device had lost a screw like the one you can see here on the right margin stop.

Did I have such a screw? No. But I realized that the problem might be solvable with a cotter pin, also known as a split pin.

Here's where the magic of paper clips comes in. They are easy to bend, but very unlikely to break unless you bend them repeatedly back and forth. I've used them to replace the C-shaped links that connect the type lever to the typebar on Olympia portables. I realized I could also use a paper clip to make a cotter pin. Using pliers, I bent the wire around a thin cylinder (the shaft of a spring hook) to create a loop. One end of the cotter pin should extend farther than the other, to make it easier to insert it into a small hole and easier to bend the tip once it's through the hole. 

The next step was to line up the holes in the margin stop, placing the spring onto the right end of the lower piece.

I worked the cotter pin through the holes, and then used a screwdriver to bend the tip of the pin.

The pin holds just fine, and the margin stop is fully functional again. Job done!